x86 Instruction Set Reference

Loads the values in the source operand into the global descriptor table register (GDTR) or the interrupt descriptor table register (IDTR). The source operand specifies a 6-byte memory location that contains the base address (a linear address) and the limit (size of table in bytes) of the global descriptor table (GDT) or the interrupt descriptor table (IDT). If operand-size attribute is 32 bits, a 16-bit limit (lower 2 bytes of the 6-byte data operand) and a 32-bit base address (upper 4 bytes of the data operand) are loaded into the register. If the operand-size attribute is 16 bits, a 16-bit limit (lower 2 bytes) and a 24-bit base address (third, fourth, and fifth byte) are loaded. Here, the high-order byte of the operand is not used and the high-order byte of the base address in the GDTR or IDTR is filled with zeros.

The LGDT and LIDT instructions are used only in operating-system software; they are not used in application programs. They are the only instructions that directly load a linear address (that is, not a segment-relative address) and a limit in protected mode. They are commonly executed in real-address mode to allow processor initialization prior to switching to protected mode.

See "SGDT-Store Global Descriptor Table Register" in Chapter 4 for information on storing the contents of the GDTR and IDTR.

if(Instruction == LIDT) {
	if(OperandSize == 16) {
		IDT.Limit = Source[0..15];
		IDTR.Base = Source[16..47] & 0xFFFFFF;
	}
	else { //OperandSize == 32
		IDTR.Limit = Source[0..15];
		IDTR.Base = Source[16..47];
	}
}
else { //Instruction == LGDT
	if(OperandSize == 16) {
		GDT.Limit = Source[0..15];
		GDTR.Base = Source[16..47] & 0xFFFFFF;
	}
	else { //OperandSize == 32
		GDTR.Limit = Source[0..15];
		GDTR.Base = Source[16..47];
	}
}

None.